Detail specification for low power dissipation numerical display for type gs1113k Gs1113k型低功耗数码显示器详细规范
Here the nixietube shows the temperature of setting , then use the key 指示灯亮,进入温度设置状态,这时数码显示器上显示的温度即为设定温度,然后用
The measured values and status of the inputs and outputs is shown on the 5 - digit digital display 测量的数值和输入输出状态通过5位数码显示器进行显示。
Set at least 2 seconds , the nixietube shows the upper limit temperature , and upper limit led lights , then using 秒,进入设置状态,这时“温度上限”灯亮,数码显示器上显示上限温度,用“
Continuously in the state of showing current temperature , and it must be finished within 3 seconds 两个键,要在三秒钟之内完成,如果密码输入正确,会进入参数设置状态,这时数码显示器上显示“
If the code is right , you can enter the state of parameter setting , here the nixietube shows fxx 1秒,如果密码输入正确,会进入参数设置状态,这时数码显示器上显示“ fxx ” ,其中xx是两位数字,表示参数代码。
Set and hold it for at least 2 seconds , the controller displays the upper limit temperature , and upper limit led lights , then using the key 秒,进入设置状态,这时“温度上限”灯亮,数码显示器上显示上限温度,用“
Set and hold it for 2 seconds , the micro - controller displays temperature that is the set temperature , then using 秒,进入温度设置状态,这时“温度设定”灯亮,数码显示器上显示设定温度,然后用上或下键改变设定值“
Set at least 2 seconds , the micro - controller displays temperature that is upper limit also the upper limit lights , then using 秒,进入温度设置状态,这时“温度上限”灯亮,数码显示器上显示上限温度,用上或下键改变设定值“
Set for at least 2 seconds , then enter the state of temperature setting , here the led displays the setting temperature , then using 秒,进入温度设置状态,这时数码显示器上显示的温度即为设定温度,然后用上或下键改变设定值“