ejection造句
例句与造句
- The most fundamental distinction is between systolic ejection murmurs and pansystolic murmurs
最基本是要分清收缩期喷射音和全收缩期杂音。 - The clinical analysis of 18 cases of gastric remnant ejection disturbance after subtotal gastrectomy
胃大部分切除术后残胃排空障碍18例临床分析 - Early and late systolic murmurs also occur and should be distinguished from ejection murmurs
在收缩早期或晚期也会出现杂音，应与喷射音相区别。 - Application research of a radial basis function neural network to fault diagnosis of electronic ejection engine
网络在电喷发动机故障诊断中的应用 - A double falciform ejection of water vapour from under the kettlelid at both sides simultaneously
从壶盖下面同时向两侧喷出两股镰刀形状的水蒸气。 - It's difficult to find ejection in a sentence. 用ejection造句挺难的
- Phenomena such as sunspots , solar wind , flares and coronal ejection are called solar activities
太阳黑子太阳风耀斑和日冕喷流等现象称为太阳活动。 - Recently it was reported that intravenous il - 2 could reduce left ventricular ejection fraction
目前对il - 2是否能通过中枢对心血管系统起作用知之甚少。 - Shusruta ' s forte was rhinoplasty ( plastic surgery ) and ophthalmialogy ( ejection of cataracts )
苏萨塔的长处是鼻整形术（整形手术）和眼炎（白内障的排出） 。 - Application of vibrating hole rotational ejection technology in cofferdam construction in nierji water complex
振孔旋喷技术在尼尔基水利枢纽围堰施工中的应用 - Progress of a coronal mass ejection observed over an eight hour period on 5 - 6 august 1999
这六帧图片捕捉了在1999年8月5日至6日期间，历时8小时的日冕抛射现象。 - Ejection murmurs begin after s1 and are usually crescendo - decrescendo ( " diamond - shaped ' ) , ending before s2
喷射音始于s1后，通常有渐强-渐弱特征，并于s2前结束。 - A case of ejection device was calculated , and the effects of different parameters on the ejection velocity were discussed
最后简要讨论了不同参数对弹射效果的影响。 - A lighter weight stencel siiis ejection seat replaced the escapac seats used in the prototypes
一个重量更轻的斯登司尔siiis型弹射座椅取代了原型机上的escapac弹射座椅。 - Here the problem of standing to sing was exaggerated with ejections carried out almost at random
在那里，站起身唱歌的问题几乎无时无刻不被（工作人员的）指责而无限放大。 - Mould should be designed with maximum cooling and with appropriate amount of ejection points
模具在设计上要做到尽快冷却，上、下内模高温点应该有个别的冷却，应有适量顶针。